Lieferung eines Spektrum- und Signalanalysators

Spectrum- and signal analyzer with the following features: - Frequency range from 2 Hz (or lower) to 43 GHz (with external harmonic mixers up to 325 GHz) - LO/IF connections for external harmonic mixers are required - RPG FS-Zxx harmonic mixers must be supported by the device - RF input: 2.92-mm male adapter, 50 Ohm impedance, DC and AC coupled - Built-in wideband RF preamplifier up to 43 GHz is required - YIG preselection with full bandwidth for image suppression - Switchable noise correction to reduce inherent noise - Frequency resolution of 0.01 Hz or better - Resolution bandwidth from 1 Hz to 10 MHz or higher - Frequency counter resolution of 0.001 Hz or better - Span: zero span (0 Hz), span ?10 Hz - Arbitrary selection of sweep points number from 101 to 50001 or more - Sweep time from 1 ?s to 10000 s or more (zero span), from 0.01 ms to 10000 s or better (span? 10 Hz) - Total measurement uncertainty below +/- 0.4 dB from 9 kHz to 8 GHz when measuring the level (signal level = 0 dB to -70 dB below the reference level, S/N > 20 dB, sweep time = auto, RF attenuation = 10 dB, 20 dB, 30 dB, 40 dB, RF preamplifier off, electronic attenuation off, span/RBW < 100, 95% confidence level, +20 °C to +30 °C) - Display average noise level (DANL) (RF attenuation = 0 dB, termination = 50 Omega, normalized to 1 Hz RBW, trace average, average mode = log, sample detector, +5 °C to +40 °C) of o less than -143 dBm from 100 kHz to 8 GHz, and of less than -135 dBm from 20 GHz to 43 GHz (RF preamplifier off) o less than -158 dBm from 100 kHz to 8 GHz, and of less than -155 dBm from 20 GHz to 43 GHz (RF preamplifier on) - Reference frequency aging of at least 4×10-8/year - Phase noise of less than -135 dBc (1 Hz), 10 kHz offset at 1 GHz carrier frequency - Signal analysis bandwidth of 2 GHz (SFDR for 2 GHz internal signal analysis bandwidth of 60 dBc or better) - 2 GHz I/Q demodulation bandwidth analysis - Real-time analysis bandwidth of 800 MHz - Multi-trace functions, and multi-trace detector options (e.g., max, min, auto, sample, RMS, average) - Multi-trigger functions and multiple trigger sources (e.g., free run, video, external, IF power, RF power, IQ) - Multi-marker functions - Supporting various measurement functions (e.g., time gate measurement, occupied bandwidth, channel power, adjacent channel power, power statistics, burst power, etc.) - Possibility to run and display multiple measurement applications in parallel - Trigger input / output: at least one - Reference clock (10 MHz, 100 MHz) input(s) / output(s) - Integrated (built-in) display - LAN 10/100/1000 Ethernet connection(s) on the device - USB ports on the device - Controllability via Ethernet (e.g., VISA) - Free software and firmware updates - Warranty period for the base unit: at least 2 years - Warranty period for the additional hardware: at least 1 year